[. . . ] GD-1340 for MC760/MC770/MC780/ES7460/ES7470/ES7480/MPS3537/MPS4242 SET-UP GUIDE Warnings Points • The unpacking and setup procedure shall be done by a qualified service technician. €¢ Be sure to unplug the power cable of the equipment before installing and setting up the product. [. . . ] In addition, pay attention not to deform parts by using too much force. €¢ When unpacking and setting up the product, be sure to wear gloves to avoid injury. â„„ Accessories H J A B E D a GD-1340 1 / 11 „„ Setup 1. • For JPD: 3 covers • Other than JPD: 2 covers 3. €¢ A: 2 * As shown in the figure, insert a flathead screwdriver into the groove and push it in the direction of the arrow to release the latches. A When using tools, be sure not to put your face and hands in the direction in which force will be applied; otherwise this could result in injury. €¢ B: 2 * As shown in the figure, insert a flathead screwdriver into the groove and push it in the direction of the arrow to release the latches. B When using tools, be sure not to put your face and hands in the direction in which force will be applied; otherwise this could result in injury. €¢ D: 1 * As shown in the figure, insert a flathead screwdriver into the groove and push it in the direction of the arrow to release the latches. D When using tools, be sure not to put your face and hands in the direction in which force will be applied; otherwise this could result in injury. F 12) Take off the upper side of the cover, release the latch (E) and then take off the cover. €¢ a: 4 When installing [A], be careful not to catch the rear side cables. [. . . ] Memory Initialization (1) Press the [ON/OFF] button while pressing [1] and [*]. (4) After the display has changed from “TESTMODE 100” to “TEST MODE CL”, shut down the equipment by pressing the [ON/OFF] button until a sound is audible. [. . . ]